The Secret To Arcade Game

We were confident that people would want to let arcade games from the month, but truth be told, we had no idea how to operate on them. Before we knew it our launch was a month off and we'd managed to accumulate about 100 matches, but only 10 of those worked!
We knew enough to refurbish a good chunk of those games, but we kept hitting the same symptom over and over again. All our monitors will display a scrambled image on the monitor. It was super frustrating because we had no idea how to repair it. We nearly missed our launching, but we eventually clued in on what exactly was causing our probablem when we learned about monitor sync 101 and recognized that they sometimes have to get hooked up differently depending on the game. On this day, we have to have turned on at least 20 games, we had already put a good deal of hard work into, but were missing this last piece of the puzzle in order to be able to play them. This very small chunk of understanding, gave us the games we needed to begin and was sufficient to keep us motivated to keep learning how to fix problems.
Five decades later, I spend more time researching arcade repair, I ever spent studying in school and the instruction proceeds to repay.
For the last couple of years, we have had an average bug that's crept into our fleet.
To fix the symptom, we'd raise the energy supply to operate hot which would be good for another 3 to six months until the power supplies would burn out. After running into this mystery a few times, we started to put the games into deep storage until we could figure out why they kept failing. Since we presumed, it had been caused by bad circuit boards trying to draw too much power, we overlooked something a lot more obvious.
After cleaning the chips, it might sometimes help, but this insect was able to brick at 20 of our matches. Well today, our Mortal Kombat 2 began to display exactly the same symptoms and quite frankly if we pull this one by the fleet, our customers will riot, so I sat down to get to the root of the case of the fall in voltage.
To do this I took my voltage meter, measured the electricity in the power source and then started spreading the 5V line and measuring wherever I could touch wire. When I measured the electricity before it went into the edge connector, I saw the voltage had already dropped. I suspected the connector between the cable and the power supply. The moment I crimped over the end of the line to place to a brand new one, I instantly saw exactly what my issue was.
We love getting a good deal and I would be willing to bet you a quarter, that you can't find a better bargain on the jamma harnesses that we purchase. Unfortunately, it looks like we may have gotten what we paid for them.
From the outside, the harness looks as though it uses a thick 18 gauge wire to conduct the power to the board. That's a whole lot of metal to run a small amount of voltage. It's part of why I suspected it was our offender.
Once you open this up though, it is possible to see that from the exterior it looks 18 gauge, but on the inside it is short quite a bit of metal. The solution was easy, https://www.jykids.net/ run a thicker wire from the power source to the harness and Voila!
While this simple bug ought to have been seen earlier and has caused us a lot of headaches, it's also incredibly exciting to work out the origin of our difficulty and to know that with hardly any work, we've got another 20 awesome matches back on our site . Learning how to correct arcade games hasn't been simple and your education never ends, but each time you solve a mystery, the next game becoming easier and easier to repair.
Hopefully, other people who've run into similar problem, can save themselves the same headache by A.) double assessing the cable you're using when you can not get your voltage to travel cleanly from your power supply into a circuit boards and B.) paying just slightly more better quality jamma harnesses.